FRONT surfboard deck grip / FRONT surfboard tail pad surfboard traction pad Australia
Sticky Johnson now also make Front surfboard grip!
NZ's best surfboard tail pad uses premium quality EVA foam and 3M adhesive. Super grippy diamond square cut means unreal traction.
- super thin 1.5mm pad base to maximise board sensitivity under foot
- 3M adhesive backing NZ surfboard grip
- diamond square cut for super grip
- premium quality EVA foam
- 3 piece
Protect your board and increase traction by applying deck grip as follows
- Make sure your board is 100% clean and dry from any wax, debris or moisture. Hint: use a Curve Power Wax Scraper to easily remove the bulk of your wax. Remove all remaining wax residue with an old rag, or rub in some fiberglass dust (ask your local shaper) or even better Sticky Johnson Wax Remover
- Position rear edge of surfboard grip over back base of your rear fin – getting close to but not overlapping leash plug. For wider boards you may want to spread the grip side bars out (taking care not to overlap rails) and for narrower boards leave as a solid pad.
- Pencil an outline of desired traction pad position.
- Line up centre surfboard grip with centre surfboard stringer and apply slowly from bottom up, avoiding air bubbles.
- Line up surf grip side bars equally and apply. Leave the traction pad for at least 12 hours to fully dry.
- Your new grip is ready to rip!
